IZOPRESS Injection Hoses – Installation Kit for 16 Sections, 6 m Each
The set includes:
- 100-meter injection hose
- 32-piece supply set
- Hose fixing bracket, 500 pcs
- Two-ear bracket, 32 pcs.
Single-braided injection hose – 100 m
Application:
- Injection hoses are used for sealing construction joints.
- They provide a reliable and durable seal for both horizontal and vertical construction joints.
- KIT DESIGNED FOR INSTALLING 16 SECTIONS – 6M.
Properties:
- Even distribution of sealing material along the entire length of the hose
- Maximum section/section length – 8 m
- Low consumption of sealing material
Technical data:
- Inner diameter – 5.8 mm
- Outer diameter – 12 mm
- Perforation – a two-hole, anti-clogging system with 8-mm cross-cuts spaced 70 mm apart and angled
- Filling volume – approx. 0.019 dm³
- Weight – 88 g/m
- Product: Hose with an elastomer core in a plastic braided design (fibers)
Supply Set for the Supply Hose – 32 pcs.
Application:
- Feeding the injection material into the injection hose from outside the concrete zone. For polyurethane, acrylic, and epoxy resins.
The supply set includes:
- feed/vent hose – 0.3 m long
- 2-eye clamp – 2 pcs.
- connector for injection hose
- Packer for injection hose with an M8 injection nipple
Two-ear bracket for injection hose – 32 pcs.
Application:
- Mounting of supply hoses with injection hoses
Injection hose mounting clamp, 500 pcs.
Application:
- Securing the injection hoses (every 20 cm)
Properties:
- Plastic
THE ENTIRE SET IS PACKAGED IN A SINGLE CARTON
General information regarding the installation of injection hoses:
- Section length: approximately 8–12 m (higher injection pressure is required for longer sections).
- The injection hose must be in contact with the concrete substrate.
- Crossing points should be avoided.
- Secure the injection hoses with special clips (metal or plastic)
- The spacing when laying the injection hoses should be 15 cm